How to make an ice dildo?
Start with the cardboard tube from a roll of paper towels. With a pair of scissors, cut the tube lengthwise all the way down its length.
Roll the tube to the diameter you’d like the finished dildo to be, and wrap tape around it to hold it at that size.
Take a condom and put it into the top of the cardboard tube, and then overlap the top half inch or so of the condom around the edge of the tube as shown in this pic. You can use a lubricated or unlubricated condom. If you use a lubricated condom, avoid spermicidally lubricated ones, because the spermicidal lubricant can get funky when it freezes.
Carefully fill the condom to the top with water. Stand the tube upright in the freezer, and wait a few hours.
In a few hours, the water will freeze. Remove the tube from the freezer. Carefully lift the top edge of the condom from around the tube and tie it in a knot to keep the water from leaking out as the ice melts. Then cut the tape holding the tube closed and remove the ice dildo.
When you’re finished, the ice dildo should look like the one shown here.
Use the dildo without removing it from the condom; as the ice melts, it will create a layer of water inside the condom that creates a very interesting sensation
Warning: You don’t want to use ice internally until it has started to melt and has a thin layer of water on its surface, or the ice may freeze to your skin.
Remember to always run the ice dildo under cool water before you use it.
Report back to me if you give a try and share your experience
Visit here for more DIY BDSM instructions